Skip to content

Griffing-Technology-LLC/engineering-pe-skills / skills/aeronautical-engineering

aeronautical-engineering

Verified

Aeronautical and aerospace engineering analysis with authoritative citations — airfoil and wing aerodynamics, lift/drag/moment build-up, propeller and EDF thrust, weight and balance, CG and static margin, V-n envelopes, and airframe load factors. Use when sizing a wing, computing lift or drag, analysing an airfoil or aerofoil section, checking CG or static margin, building a V-n diagram, sizing a propeller or ducted fan, doing a weight-and-balance or mass-properties roll-up, or evaluating a UAS or light aircraft airframe against FAA Part 23/107, NASA, or ASTM F38 standards.

FileKindSize
SKILL.mdskill md9.0 KB
references/aerodynamics.mdmarkdown4.5 KB
references/loads-and-factors.mdmarkdown8.2 KB
references/propulsion.mdmarkdown3.1 KB
references/weight-and-balance.mdmarkdown3.0 KB

references/weight-and-balance.md

View on GitHub
# Weight, Balance, and Static Margin

Reference file for the `aeronautical-engineering` skill.

## 1. Mass properties roll-up

Every component gets a mass and a station. The rule from the project standard:
**no "TBD" values.** An estimate with a stated basis and uncertainty is
engineering; a TBD is a deferred failure.

Report mass in `lbm (kg)`. Longitudinal station $x$ is measured from a stated
datum — name the datum explicitly, since a CG figure without its datum is
unusable.

$$x_{cg} = \frac{\sum m_i x_i}{\sum m_i}$$

Same form for lateral and vertical CG. For a multi-rotor or tilt-nacelle
aircraft, lateral balance is a live constraint, not a formality.

**Moment of inertia** about the CG, needed for any dynamic or control analysis:

$$I = \sum \left( I_{cg,i} + m_i d_i^{2} \right)$$

the parallel-axis theorem. Neglecting the $I_{cg,i}$ term is acceptable only for
components small relative to their offset — state when that approximation is made.

## 2. CG envelope

CG is not a point; it is a range swept as payload and energy are consumed. Compute
the CG at every corner of the loading matrix:

* empty
* max payload, full battery/fuel
* max payload, depleted
* zero payload, full
* zero payload, depleted

The **forward** and **aft** extremes bound the envelope, and both must satisfy the
stability and control criteria. A design balanced only at one loading is not
balanced.

## 3. Neutral point and static margin

The neutral point $x_{np}$ is the CG location at which the aircraft is neutrally
stable in pitch. For a conventional wing-plus-tail configuration:

$$
\frac{x_{np}}{\bar{c}} = \frac{x_{ac}}{\bar{c}}
+ V_H \frac{a_t}{a_w}
\left(1 - \frac{\mathrm{d}\varepsilon}{\mathrm{d}\alpha}\right)
$$

with horizontal tail volume coefficient:

$$V_H = \frac{l_t S_t}{\bar{c} S_w}$$

where $l_t$ is the tail arm, $S_t$ tail area, $\bar{c}$ mean aerodynamic chord,
$a_t$ and $a_w$ the tail and wing lift-curve slopes, and
$\mathrm{d}\varepsilon/\mathrm{d}\alpha$ the downwash gradient.

**Static margin:**

$$SM = \frac{x_{np} - x_{cg}}{\bar{c}}$$

Positive static margin means statically stable in pitch. The margin must be
positive **across the whole CG envelope**, not merely at the nominal loading.

The downwash gradient is configuration-dependent and is a common place for
fabricated numbers to enter an analysis. Cite it or compute it; if estimated,
label it `ASSUMED` and carry the sensitivity.

## 4. Configurations where this formulation does not apply

The tail-volume formulation above assumes a conventional wing-plus-aft-tail
layout. It does **not** transfer unmodified to:

* tailless and flying-wing configurations
* canard configurations (the stability contributions reverse)
* tilt-rotor / tilt-nacelle aircraft, where the thrust line moves through the
  transition and the CG-relative thrust moment changes sign

For a tilting-propulsion aircraft, pitch balance must be evaluated **at each tilt
angle through the transition**, not only in cruise and hover. The critical
case is usually mid-transition, and it is routinely missed.
slack-gif-creatoranthropics/skillsKnowledge and utilities for creating animated GIFs optimized for Slack. Provides constraints, validation tools, and animation concepts. Use when users request animated GIFs for Slack like "make me a GIF of X doing Y for Slack."Stars: 198kUpdated Claude CodeCodexVerifiedInstall
ponytailDietrichGebert/ponytailLazy senior dev mode for any coding task: the smallest change that fully solves it, and a reply a busy human understands in one read.Stars: 194kUpdated Claude CodeCodexVerifiedInstall
ponytail-debtDietrichGebert/ponytailHarvest every shortcut: comment into one debt ledger, so deferrals get tracked instead of forgotten. One-shot report.Stars: 194kUpdated Claude CodeCodexVerifiedInstall
ponytail-debtDietrichGebert/ponytailList every `shortcut:` comment (and older `ponytail:` ones) as a debt ledger. One-shot report, changes nothing. Use for "ponytail debt", "what did ponytail defer", "list the shortcuts", /ponytail-debt.Stars: 194kUpdated Claude CodeCodexVerifiedInstall